Manual Evo 8.0 - PhotoBooth Digital Centre

The control Board is the green board located behind the PC. It doesn’t mean that the
Control Board is bad; it could mean that the PC could not connect with the Control
Board (because the Serial cable is not correctly connected).
Check following points:
1· Check the Control Board Serial Connection “P.2”. (That is the common problem point).(attach
2 pictures: Correct and Error “Please Wait”). This connection is very easy to
lose during transport, or when you work at that area.
2· If all connections are good, then check that the Control Board Red LED is ON.
3· If all the 2 points are OK, but still doesn’t work, please send the Control Board to
Digital Centre (contact the Support Team before sending)
P.2
13.10 CONTROL BOARD ERROR
P.2 Serial Cable From Control Board to PC. (56 cm - Inch 22,04)
P.2
Red LED is ON
88