Operating Manual - SCHNIER Elektrostatik GmbH
Operating Manual - SCHNIER Elektrostatik GmbH
Operating Manual - SCHNIER Elektrostatik GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3 Imax switchoff in Umode<br />
1: If the output current in Umode<br />
is higher than the<br />
threshold value in object -<br />
dictionary.<br />
0: If this failure does not<br />
exist or is quitted.<br />
4 Sparkover switchoff 1: If a sparkover happens.<br />
0: If this failure does not<br />
exist or is quitted.<br />
5 Reserve<br />
6 Reserve<br />
7 Node Guarding Failure<br />
1: If Nodeguarding signal is<br />
broken.<br />
0: If this failure does not<br />
exist or is quitted.<br />
3 0 Invalid Parameter 1: If any Parameter in the<br />
Object dictionary is set by<br />
an invalid value.<br />
0: If this failure does not<br />
exist or is quitted.<br />
1 U Measurement<br />
Failure<br />
2 I Measurement<br />
Failure<br />
3 Internal Power<br />
Failure<br />
4 Reserve<br />
5 Reserve<br />
6 Reserve<br />
7 Reserve<br />
1: If the voltage measurement<br />
circuit is defect.<br />
0: If this failure does not<br />
exist or is quitted.<br />
1: If the current measurement<br />
circuit is defect.<br />
0: If this failure does not<br />
exist or is quitted.<br />
1: If intern power controlling<br />
does not funktion.<br />
0: If this failure does not<br />
exist or is quitted.<br />
Check why CAN<br />
master does not<br />
send Nodeguard<br />
periodically as defined<br />
in the object<br />
0x100C<br />
Check value range<br />
of parameters sent<br />
to the HV controller<br />
Has to be checked<br />
by manufacturer if<br />
failure persists<br />
Has to be checked<br />
by manufacturer if<br />
failure persists<br />
Has to be checked<br />
by manufacturer if<br />
failure persists<br />
<strong>Operating</strong> Instructions 810364_BAL_EN120302 Stand 02.03.2012 Seite 21 von 25
Change language