Operating Manual - SCHNIER Elektrostatik GmbH

More documents

Recommendations

Info

8.3. Additional Parameter Settings using SDOs The following parameters are set using SDOs: Threshold of Umin-switchoff HV generator is switched off if, during constant-I-mode, output voltage drops below this value Threshold of Umax-warning During constant-I-mode the output voltage is limited to this value. A warning wil be issued if Umax is reached. Threshold of Imax-switchoff HV generator is switched off if, during constant-U-mode, output current reaches this value Sensitivity of sparkover detection This value defines the sensitivity of spark detection. Do not change! Voltage run up ramp Output voltage ramp up speed after HV is switched on 8.4. Interface Description File EDS EDS files are simple text files used by network configuration tools to help you identify products and easily commission them on a network. SCHNIER provides a eds-File with all parameter and format information of the HV generator. Operating Instructions 810364_BAL_EN120302 Stand 02.03.2012 Seite 22 von 25
8.5. Overview Control and Status Word Operating Instructions 810364_BAL_EN120302 Stand 02.03.2012 Seite 23 von 25
Page 1 and 2: 1 Operating Manual HV Generator sma
Page 3 and 4: 1. Product and Manufacturer 1.1. Pr
Page 5 and 6: 3. Intended Use This Product is ded
Page 7 and 8: 4. Installation 4.1. Description 1
Page 9 and 10: 4.2. Dimensional Drawing Operating
Page 11 and 12: High Voltage Connector The 4mm HV P
Page 13 and 14: 5.1. Safe shut down of the high vol
Page 15 and 16: 7.3. Block Diagram 24 VDC CANopen P
Page 17 and 18: put voltage will be hold constantly
Page 19 and 20: 8.1.Description of Control Word Byt
Page 21: 3 Imax switchoff in Umode 1: If the
Page 25: 9. Declaration of Conformity Herste

Operating Manual - SCHNIER Elektrostatik GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?