Control Point® Addendum - DICKEY-john Corporation

More documents

Recommendations

Info

If YES is selected, the following screens will appear. CALIBRATION OF BARGRAPH YES Once the tank level has been enabled, the text PRESS C TO CAL TANK LEVEL appears at the bottom of the liquid configuration screen. Press C and the calibration screen will appear. TANK EMPTY This value can be entered manually or automatically captured. 11001-1258-200311 Manual Entry Select the TANK EMPTY text and enter the empty voltage from the manufacturer’s specifications. Automatic Entry Insure that the tank is empty and the sensor is installed and connected. Select the TANK EMPTY text and press “C” to capture the sensor voltage. <strong>Control</strong> Point version 6.40 software addendum 3
TANK FULL This value can also be entered manually or automatically captured. Manual Entry Select the TANK FULL text and enter the full voltage from the manufacturer’s specifications. Automatic Entry Insure that the tank is full and the sensor is installed and connected. Select the TANK FULL text and press “C” to capture the sensor voltage. TANK ALARM This is a user definable value that will inform the driver when the tank level has reached the alarm limit. This value has a built in 5% hysteresis to prevent random alarming due to varying tank level while driving. (i.e. if TANK ALARM is 10% the alarm will activate when the level drops below 10%, but will not be cleared until the level reaches 15%.) The audible alarm will sound for the first 5 seconds then the text will flash on the screen until the condition is cleared or another alarm is issued. CALIBRATION OF BARGRAPH NO TANK EMPTY This value can be entered manually or automatically captured. Manual Entry Select the TANK EMPTY text and enter the empty voltage from the manufacturer’s specifications. Automatic Entry Insure that the tank is empty and the sensor is installed and connected. Select the TANK EMPTY text and press “C” to capture the sensor voltage. TANK FULL This value can also be entered manually or automatically captured. Manual Entry Select the TANK FULL text and enter the full voltage from the manufacturer’s specifications. Automatic Entry Insure that the tank is full and the sensor is installed and connected. Select the TANK FULL text and press “C” to capture the sensor voltage. TANK ALARM This is a user definable value that will inform the driver when the tank level has reached the alarm limit. This value has a built in 5% hysteresis to prevent random alarming due to varying tank level while driving. (i.e. if TANK ALARM is 100 gallons on a 1000 gallon capacity the alarm will activate when the level drops below 100 gallons, but will not be cleared until the level reaches 150 gallons.) The audible alarm will sound for the first 5 seconds then the text will flash on the screen until the condition is cleared or another alarm is issued. 4 <strong>Control</strong> Point version 6.40 software addendum 11001-1258-200311
Page 1 and 2: Control Point ® Version 6.4 Addend
Page 3: The purpose of this addendum is to
Page 7 and 8: The initial gate height screen has
Page 9 and 10: CONFIGURATION The initial road temp
Page 11 and 12: If YES, the following screen will a
Page 13 and 14: The 12V switched output works diffe
Page 15 and 16: If GSRS is YES the spinner configur
Page 17 and 18: CALIBRATION MIN PRESS This value ca
Page 19 and 20: Manual Entry Select the BED ALARM t
Page 21 and 22: Below is of the drawing for the new

Control Point® Addendum - DICKEY-john Corporation

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?