Control Point® Addendum - DICKEY-john Corporation

OPERATOR NOTES:
1. If the voltage from the sensor is outside the range between the CLOSED and OPEN position values,
the display will state GATE LOW or GATE HIGH. If GATE LOW is displayed, the signal from the
sensor is exceeding the CLOSED voltage. If GATE HIGH is displayed, the signal from the sensor is
exceeding the OPEN voltage. In either case, an alarm will be activated notifying the driver. The alarm
will tell the driver to check the gate height and set the gate to X.X (the gate height at which the
granular calibration was ran) for that granular channel.
2. If the gate height is enabled and has been calibrated, all of the desired granular materials that have
been enabled must be recalibrated through a material drop test. Refer to calibrating granular materials
(F6) in the Control Point manual. If materials that have been enabled are not calibrated the
Control Point will alarm.
Road Temperature Sensor
This sensor is used to monitor the road temperature and notify the driver of road temperature changes.
There are three temperature alarm settings that can be set to alert the operator. The road temperature
sensor will be connected to the Road Watch Adapter (466492000S1). The Road Watch Adapter is connected
to the main harness on the cable labeled TEMPERATURE or to the mating connector in the adapter harness
(466492040S1) on earlier version Control Point harnesses. When enabled, the road temperature will be
displayed in the lower left side of the operate screen. The configuration for the road temperature sensor is
found under Miscellaneous (F12), More (6), Road Temperature Sensor (2).
11001-1258-200311
Control Point version 6.40 software addendum 7