MB9A110 Series - Fujitsu

MB9A110 Series
70
(4-1) Operating Conditions of Main PLL (In the case of using main clock for input clock of PLL)
(Vcc = 2.7V to 5.5V, Vss = 0V, Ta = - 40°C to + 105°C)
Value
Parameter Symbol Min Typ Max Unit Remarks
PLL oscillation stabilization wait time
(LOCK UP time)*
tLOCK 100 - - μs
PLL input clock frequency fPLLI 4 - 16 MHz
PLL multiple rate - 13 - 75 multiple
PLL macro oscillation clock frequency fPLLO 200 - 300 MHz
*: Time from when the PLL starts operating until the oscillation stabilizes.
(4-2) Operating Conditions of Main PLL (In the case of using built-in high speed CR)
(Vcc = 2.7V to 5.5V, Vss = 0V, Ta = - 40°C to + 105°C)
Value
Parameter Symbol Min Typ Max Unit Remarks
PLL oscillation stabilization wait time
(LOCK UP time)*
tLOCK 100 - - μs
PLL input clock frequency fPLLI 3.8 4 4.2 MHz
PLL multiple rate - 50 - 71 multiple
PLL macro oscillation clock frequency fPLLO 190 - 300 MHz
*: Time from when the PLL starts operating until the oscillation stabilizes.
Note: It needs to input to PLL by built-in CR trimming frequency.
(5) Reset Input Characteristics
(Vcc = 2.7V to 5.5V, Vss = 0V, Ta = - 40°C to + 105°C)
Parameter Symbol
Pin
name
Value
Conditions
Min Max
Unit Remarks
Reset input time tINITX INITX - 500 - ns
(6) Power-on Reset Timing
Parameter Symbol
(Vcc = 2.7V to 5.5V, Vss = 0V, Ta = - 40°C to + 105°C)
Pin
name
Value
Min Max
Unit Remarks
Power supply rising time Tr 0 - ms
Vcc
Power supply shut down time Toff
1 - ms
Vcc
Tr Toff
0.2V
2.7V
0.2V
0.2V
DS706-00011-1v0-E