ETERNUS DX60/DX80/DX90 Disk storage system User Guide - Fujitsu

Chapter 5 Installation
5.2 Rack Installation
■ 2.5" type drive enclosure
• Use the thumb screw to fasten the front right of the drive enclosure to the rack.
• After attaching the supplied flange cover, use the thumb screw to fasten the front left of
the drive enclosure to the rack.
For details on how to attach the flange cover, refer to "3.4 Attaching and Removing the
Flange Cover" (page 78).
Thumb screw
8 For 3.5" type drive enclosures, finish by replacing the front cover.
For details on how to attach the front cover, refer to "3.3 Attaching and Removing the Front
Cover" (page 75).
5.2.3 Installing AC Outlet Box (1U)
This section describes how to install the 1U AC outlet box in a rack.
CAUTION
Do Not
(Rear rack pillars)
100
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
End of procedure
• AC outlet box cannot be connected to the device other than
ETERNUS DX60/DX80/DX90.
Copyright 2011 FUJITSU LIMITED P3AM-3042-08ENZ0