ETERNUS DX60/DX80/DX90 Disk storage system User Guide - Fujitsu
ETERNUS DX60/DX80/DX90 Disk storage system User Guide - Fujitsu
ETERNUS DX60/DX80/DX90 Disk storage system User Guide - Fujitsu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 6 Cable Connection<br />
6.3 Fibre Channel Cable Connection (For Fibre Channel)<br />
CAUTION<br />
■ Fibre Channel cable connection procedure<br />
The following explains how to connect the Fibre Channel cable.<br />
This section explains how to connect the Fibre Channel cable to the <strong>ETERNUS</strong> <strong>DX60</strong>/<strong>DX80</strong>. For<br />
the <strong>ETERNUS</strong> <strong>DX90</strong>, each controller has four Fibre Channel ports.<br />
IMPORTANT<br />
• Fibre Channel cable is thin and breaks easily, so be careful not to<br />
pinch the cable between devices or bend it too much. Keep a 30mm<br />
or larger radius when bending Fibre Channel cable. Failure to do so<br />
may cause device damage or failure.<br />
90˚<br />
30mm<br />
or larger<br />
Do not bend square Do not bind up<br />
• To help with Fibre Channel cable management and prevent incorrect<br />
connections, attach labels to the Fibre Channel cables and make a note<br />
of connection origins and destinations.<br />
• When connecting the Fibre Channel cable, check the direction of the<br />
connector tab and insert it all the way in firmly.<br />
When disconnecting the Fibre Channel cable, pull out the connector<br />
while holding its tab.<br />
This section describes dual controller model as an example. Note that there<br />
is only controller 0 (CM#0) for single controller model.<br />
112<br />
<strong>ETERNUS</strong> <strong>DX60</strong>/<strong>DX80</strong>/<strong>DX90</strong> <strong>Disk</strong> <strong>storage</strong> <strong>system</strong> <strong>User</strong> <strong>Guide</strong><br />
Copyright 2011 FUJITSU LIMITED P3AM-3042-08ENZ0
Change language