PGO PMX Sport (PM) servicemanual - Scootergrisen

More documents

Recommendations

Info

6.Screwing out the two M6-nut of muffler and cylinder, and the two M8-bolt of crankcase. 7.Remove muffler. 8.Remove the four M7-nut of cylinder head, then remove cylinder head and cylinder head gasket.
9.Remove the C-type clip on the piston and piston pin by the nipper. Take off piston. 10.Dismantling of the piston ring Remove the lst ring, then 2 nd ring. 11.When assembling, please reverse the procedures of dismantling Locking torque: M7:1.0-1.4kg-m M6:1.0-1.2kg-m Opening end of piston ring
Page 3:
(12)Fuel tank, oil tank 5.Electric
Page 9 and 10:
3.Other parts: Please refer the fol
Page 11:
C. Wheel bearing part
Page 14 and 15:
2.Weak acceleration: Check and Adju
Page 17 and 18: 4.Engine running unsmoothly (high s
Page 20 and 21: 9.Oil indicator malfunction (a)The
Page 22 and 23: (b)Fuel gauge needle is not steady
Page 24 and 25: (b)Starting motor running slowly or
Page 27: 3.Checking and Adjustment: (1)Regul
Page 34: (5)Spark plug 1.Remove spark plug 2
Page 40 and 41: 4.Dismantling, maintaining, repairi
Page 42 and 43: 3.Removing oil pump. Clean the oil
Page 44 and 45: (2)Dismantling & assembling of plas
Page 46 and 47: 6.Screwing out the screws of left s
Page 48 and 49: 9.Take off the upper & lower handle
Page 50 and 51: 13.Disconnect the negative cable fi
Page 52 and 53: 4.Remove the cap of spark plug. 5.R
Page 54 and 55: (4)Drive pulley, starter, clutch, d
Page 56 and 57: 3.Remove the fixing nut of clutch.
Page 58 and 59: 9.Assenbke driving pulley, please r
Page 60 and 61: D. Starter dismantling 1.Dismantle
Page 62 and 63: c. Check driven spring free length:
Page 64 and 65: C-2. PISTON & CYLINDER DATAS for 50
Page 68 and 69: E. Check for the flatness of cylind
Page 70 and 71: 4.Piston outer diameter measurement
Page 72 and 73: 8.Check connecting rod small end (1
Page 74 and 75: 5.Remove the flywheel. 6.Remove the
Page 76 and 77: 3.Remove the bolt in gear box cover
Page 78 and 79: (8)Crankcase, Crankshaft: A. Disass
Page 80 and 81: D. Dismantle the crankcase and cran
Page 82 and 83: 7.Remove cylinder, AC flywheel magn
Page 84 and 85: 3.measure the swingness of crank sh
Page 87 and 88: C. Troubleshooting: a. Engine can n
Page 89 and 90: F. Reed valve 1.Dismantling reed va
Page 91 and 92: (10)Steering column, front wheel, f
Page 93 and 94: D. Steering handlebar. 1.Remove the
Page 95 and 96: F. Front wheel: 1.Remove the lockin
Page 97 and 98: F. Front Brake 1.Disassembling and
Page 99 and 100: G. Front fork 1.Front fork system d
Page 101 and 102: C. Disassembling and assembling the
Page 103 and 104: F. Rear damper 1.Rear damper disass
Page 105 and 106: C. Fuel tank dismantling and assemb
Page 107 and 108: D. Oil tank disassembling diagram:
Page 109 and 110: (1)Troubleshooting: A. Recharge sys
Page 111 and 112: 2.Testing the recharging performanc
Page 113 and 114: 2.Check A.C. Generator a. Open the
Page 116:
2.check the starter Connect green/w
show all

PGO PMX Sport (PM) servicemanual - Scootergrisen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?