Peugeot workshop manual Jet Force (756739) - Scootergrisen
Peugeot workshop manual Jet Force (756739) - Scootergrisen
Peugeot workshop manual Jet Force (756739) - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SPECIAL WORK AND PROCEDURES WITHOUT REMOVING THE ENGINE<br />
Important: Put the injector in the holder tool<br />
P/N 755986 until ready for refitting<br />
Note: The injector may only be removed for a<br />
short instant from its housing in the cylinder<br />
head, as the air injector has a Teflon seal which<br />
expands if it is not held compressed<br />
Reassembly: Re-assemble in the reverse order<br />
to dismantling<br />
Check: Using the diagnostic tool, check for<br />
fault codes, clear them if necessary<br />
Removal of the thermostat (50 cc)<br />
- Remove the cylinder head (see procedure 5)<br />
- Remove the circlip (1) from the thermostat (2)<br />
- Remove the thermostat<br />
When refitting, make sure the thermostat (2)<br />
circlip (1) is correctly fitted, as shown<br />
Note: The thermostat circlip must be changed<br />
each time it is removed<br />
Reproduction or translation, even partial, are forbidden without the written consent of <strong>Peugeot</strong> Motocycles<br />
Page : 41
Change language