Peugeot workshop manual Jet Force (756739) - Scootergrisen

More documents

Recommendations

Info

Removal of the engine mounting twin linkrod - Remove the storage compartment (see procedure 2) - Remove the left-hand footboard and tunnel - Disconnect the battery - Disconnect the oil vapour return pipe to the air filter - Disconnect the atmospheric pressure sensor - Remove the air filter unit - Disconnect the starter motor, the idle valve and the fuel injector - Disconnect the magneto harness and engine harness connections - Slacken off the upper mounts (1) of the engine mounting twin linkrod (2) - Slacken off and remove the twin linkrod lower securing pin (3) Note: Suspend the machine or wedge it under the swingarm twin linkrod - Remove the twin linkrod upper fixing pins - Remove the twin linkrod and the 2 rubber bump stops (4) Page : 54 125 cc SPECIFIC MISCELLANEOUS WORK Reproduction or translation, even partial, are forbidden without the written consent of <strong>Peugeot</strong> Motocycles
Method of fitting the engine mounting twin linkrod - Fit the 2 rubber bump stops (1) to the frame - Fit the twin linkrod (2) to the frame taking care it lines up with the rubber bump stops - Fit the twin linkrod upper fixing pins (3) - Fit the twin linkrod lower fixing pin (4) 125 cc SPECIFIC MISCELLANEOUS WORK Reproduction or translation, even partial, are forbidden without the written consent of <strong>Peugeot</strong> Motocycles Page : 55
Page 1 and 2:
SALES DIVISION NETWORK TECHNICAL IN
Page 3 and 4: CONTENTS Removal of the storage com
Page 5 and 6: CHARACTERISTICS Engine CHARACTERIST
Page 7 and 8: SERVICE SCHEDULE AND COMMISSIONING
Page 9 and 10: TIGHTENING TORQUES Body panels TIGH
Page 11 and 12: INSTRUMENT CLUSTER Instrument clust
Page 13 and 14: INSTRUMENT CLUSTER Changing the dis
Page 15 and 16: CONTROL CABLE AND HARNESS ROUTINGS
Page 17 and 18: Left-hand side 125 cc CONTROL CABLE
Page 19 and 20: LOCATION OF COMPONENTS 50 cc 1. Inj
Page 21 and 22: BODY Location of body components (5
Page 23 and 24: Removal of the storage compartment
Page 25 and 26: - Remove the rear shield (6) (3 scr
Page 27 and 28: Removal of the frame (50 cc) This m
Page 29 and 30: MISCELLANEOUS OPERATIONS Removal of
Page 31 and 32: Removal of the fuel gauge (50 cc) -
Page 33 and 34: Removal of the fuel tank filler rin
Page 35 and 36: Removal of the radiator deflector (
Page 37 and 38: WORKING ON THE ENGINE WITHOUT REMOV
Page 39 and 40: SPECIAL WORK AND PROCEDURES WITHOUT
Page 45 and 46: Removal of the starter motor and/or
Page 47 and 48: ENGINE REMOVAL Removal of the 50 cc
Page 49 and 50: Removal of the fuel injector - Remo
Page 51 and 52: Removal of the fuel pump / of the f
Page 53: Removal of the rear brake pads or c
Page 57 and 58: 125 cc SPECIFIC WORK REQUIRING ENGI
Page 59 and 60: Reproduction or translation, even p
show all

Peugeot workshop manual Jet Force (756739) - Scootergrisen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?