Whiplash Testing Protocol - Euro NCAP

More documents

Recommendations

Info

9.4 Check the angle of the installed calibrated surface block with a digital inclinometer to ensure that it shows a reading of 90 (± 0.3). Version 3.1 June 2011 Figure 10. Calibrated Torso angle measurement surface block attached to trunk of weight hanger arm. 10. Marking of H-PM/HRMD Units 10.1 An indelible metallic self adhesive label should be attached to the H-PM on LH back pan spine to back pan bracket. 10.2 An identical label should be attached to the HRMD above the build plate. 10.3 These labels should have the following information: - Calibration Date - Calibration Centre - Serial numbers of the two units The label should also contain the following text: “Calibrated to H-PM/HRMD standard” Figure 11. The label on the H-PM Figure 12. The label on the HRMD 51
11. Checking the H-Point Torque 11.1 After the two machines are calibrated together, set the torque on the H-point weight hanger pivot to 3.4 Nm (30 in-lbs). This can be done with a torque wrench. Version 3.1 June 2011 52
Page 1 and 2:
EUROPEAN NEW CAR ASSESSMENT PROGRAM
Page 3 and 4: CONTENTS 1 INTRODUCTION ...........
Page 5 and 6: 2 DEFINITIONS For the purpose of th
Page 7 and 8: 3 COORDINATE SYSTEM 3.1 Sled Coordi
Page 9 and 10: Version 3.1 June 2011 Figure 1: Sea
Page 11 and 12: 4.6 Seat Position Version 3.1 June
Page 13 and 14: Version 3.1 June 2011 Alternatively
Page 15 and 16: 4.6.2.7 Seat adjustments not set in
Page 17 and 18: 5 H-POINT MACHINE & DUMMY POSITIONI
Page 19 and 20: 5.3.21 When each foot is in its fin
Page 21 and 22: 6 HEAD RESTRAINT POSITIONS 6.1 Head
Page 23 and 24: 6.2.3.1.5.4 If there is no locking
Page 25 and 26: Version 3.1 June 2011 Probe displac
Page 27 and 28: Version 3.1 June 2011 only be under
Page 29 and 30: 7 BioRID ATD REQUIREMENTS The tests
Page 31 and 32: 7.3.3 Legs 7.3.3.1 Remove the jacke
Page 33 and 34: 8 TEST SLED REQUIREMENTS 8.1 Accele
Page 35 and 36: Version 3.1 June 2011 Camera View 1
Page 37 and 38: Version 3.1 June 2011 Figure 16: Vi
Page 39 and 40: 11.3 Upper Neck Shear Force (Fx) an
Page 41 and 42: 11.6 Nkm Calculation The following
Page 43 and 44: values. Maxima for each of the four
Page 45 and 46: Appendix II Version 3.1 June 2011 R
Page 47 and 48: in and out of the head and has grad
Page 49 and 50: 5.4 Adjust the rear Concentric Adju
Page 51 and 52: Version 3.1 June 2011 Zero to 4mm g
Page 53: Version 3.1 June 2011 Figure 8. HRM
Page 57 and 58: Appendix III Below is an extract fr
Page 59 and 60: Appendix IV 1. Definitions Version
Page 61 and 62: F 13.1 4.0982 R 16 4.25 G 5 6.00 S
Page 63 and 64: G 17 11.00 O 100 -1.00 H 37 11.00 P
Page 65 and 66: H 15 9.50 T 110.7 0.00 I 15 8.75 U
Page 67 and 68: Seat Tilt - An adjustment that rota
Page 69 and 70: Head Restraint Tilt - An adjustment
show all

Whiplash Testing Protocol - Euro NCAP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?