Whiplash Testing Protocol - Euro NCAP
Whiplash Testing Protocol - Euro NCAP
Whiplash Testing Protocol - Euro NCAP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Version 3.1<br />
June 2011<br />
Figure 1: Seat reference point<br />
Seat Reference Point<br />
4.3 Toe Board<br />
The toe board is defined as a simulated floor and toe pan, consisting of a horizontal section<br />
sufficiently large to rest the dummy‟s feet and connected to a section oriented 45° from the<br />
horizontal. When positioned for test, the gap between the front of the seat and rear of the toe board<br />
shall be no more than 100mm. Both surfaces shall be covered with short-piled carpet. A suitable<br />
arrangement is illustrated in Figure 2.<br />
Figure 2: Toe board arrangement showing correct positioning of BioRID feet<br />
4.4 Heel Surface<br />
The heel surface is defined as the horizontal plane of the toe board (i.e. sled floor or movable<br />
footrest) on which the dummy‟s heel rests. Its target position is determined using the heel rest point<br />
location defined from the vehicle measurements, or from information provided by the vehicle<br />
manufacturer. An accurate height setting should be obtained at this stage; however an initial<br />
approximated horizontal position may be set. The final horizontal position will be obtained in<br />
Section 6.6.8.<br />
4.4.1 Determine heel rest point location. The heel rest point is defined in the vehicle (with<br />
removable floor mats not fitted) by using the accelerator pedal as follows:<br />
6