Whiplash Testing Protocol - Euro NCAP
Whiplash Testing Protocol - Euro NCAP
Whiplash Testing Protocol - Euro NCAP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Appendix III<br />
Below is an extract from the ICBC Instruction Manual for the HRMD, Section 3.<br />
3. PRELIMINARY ADJUSTMENTS TO THE HRMD AND H-POINT MACHINE<br />
3.1 Remove the head room probe from the H-point machine and install the two washers (supplied<br />
with the HRMD) in the spaces remaining on the H-point pivot.<br />
3.2 To accommodate the manufacturing variances in the SAE H-point machines, the fit of the<br />
HRMD on the individual H-point machine should be confirmed as follows.<br />
3.2.1 Place the H-point machine seat-back and pan in a “sitting position”. Lower the HRMD in<br />
position onto the torso weight hangers and onto the top edge of the channel between the torso weight<br />
hangers. Before handling the HRMD confirm the knob below the back of the headform is finger<br />
tight.<br />
3.2.2 To ensure the HRMD fits easily over the channel between the torso weight hangers and to<br />
prevent damage to the spring plungers, the channel must be chamfered in accordance with RONA<br />
Kinetics and Associates Ltd. Drawing No. 10045, see below.<br />
3.2.3 If there is fore-aft movement of the headform assembly (with the rear knob on the HRMD<br />
finger tight), adjust the spring plungers in the HRMD retainer plate until there is no further<br />
movement.<br />
Version 3.1<br />
June 2011<br />
54