Download 265R PDF - EXPRESSCUBE.com

7.4.2. Manual / Automatic Operation
This selection provides an option for an automatic recording of the measurement data after
the data is collected. The automatic operation can significantly speed the measurement
process and is used when there is no requirement to review acquired measurements before
recording them.
Manual Operation: If the ExpressCube is in a ready state to record the measurement, the
user will press the Acquire key or (if equipped) the trigger of the handheld scanner. The
acquired measurement data will be displayed but the user must activate the SEND / PRINT
key to record the data. Removal of the package from the platform will clear any acquired
measurements and prepare the device for a new measurement sequence.
Automatic Operation: If the ExpressCube is in a ready state to record the measurement,
the user will press the trigger of the handheld scanner (if equipped). The ExpressCube will
record the measurements and automatically send the acquired data with the bar code as if
the SEND button had been pushed. All acquired data will remain in the display until the
parcel is removed from the ExpressCube platform.
In Operating Software Versions 4.0.20 and later [manufactured after Jan/2011] the
automatic operation will also permit the Acquire Button to Acquire & Send data in one
operation.
Sub-menu:
MANUAL / AUTOMATIC OPERATION
1. MANUAL
2. AUTOMATIC
3. GO BACK
4. EXIT
Press the appropriate number to select the desired operation mode. The current selection
will be indicated by the beside it. After verifying the correct selection, use
EXIT function to return to the main menu.
7.4.3. Adjust Beep Duration
This selection displayed but the beep tone is not used in the 265R model.
17