Download 265R PDF - EXPRESSCUBE.com

7.4.5. Calibrate Lenses
1) Remove any boxes from the platform and gently wipe any accumulated dust from the
surface of the lens with a cloth, towel, etc.
2) From under the machine, turn the machine OFF by toggling the white power switch.
3) Disconnect the USB connector (located beside the power cable).
4) From under the machine, turn the machine ON by toggling the white power switch. The
lights on the top of the machine will flicker with the red power indicator becoming steady.
5) ON the LCD Controller located by the machine, press the PROG button. A menu will
appear.
6) Press the number 5 key “Calibrate Dimensional Banks”
7) Verify that the platform is empty, then press number 1 key “Calibrate Dimensional
Banks”
8) During the calibration process the Blue light will flash, then the Yellow, then the Green
and finally the Blue light will flash. When the flashing has stopped, the lens has finished
calibrating.
9) Hit the PROG key to quickly return to normal operation.
10) From under the machine, turn the machine OFF by toggling the white power switch.
11) Reconnect the USB connector (located beside the power cable).
12) From under the machine, turn the machine ON by toggling the white power switch. The
lights on the top of the machine will flicker with the red power indicator becoming steady.
.
Note: It is not necessary to power the ExpressCube Off & ON if the USB cable is
not used.
19