Installatie instructie horizo... - Climarad

More documents

Recommendations

Info

Step 5. Attach wall plates and radiator mountings 5F X Table 5G: Dimensions extra consoles for long radiators Radiatortype 11/22s 1920 Distance X (mm) X 400 2080 480 5.8 For extreme long radiators, which need extra holding frames, 2 extra consoles can be mounted to the wall. See table 5G for all dimensions to be used for drilling the holes and fixing the extra consoles. 2240 560 2400 640 2720 3040 800 960
Step 6.Fitting the ClimaRad ventilation-unit 6A 6B 6C 6D 6E lift here 2X vastdraaien 2 1 2X 6.1 Take the ClimaRad ventilation-unit out of the packaging and remove the metal hood. Put the hood away in a safe place. Note! When multiple ClimaRads are installed in one room, that will use only one Master control, than you should take care that the Master and Slave-units are placed on the right location. 6.2 Fit the ClimaRad ventilation-unit on the radiator-supports behind the clamps. Make sure the threaded pins on the wall plates are inserted into the sesignated holes in the back of the ClimaRad ventilation-unit. 6.4 Fasten the ventilation-unit to the wall-plates with the supplied plastic screws. 6.5 Fixate the bottom of the ClimaRad ventilation-unit by screwing the lower bolt of each clamp (spanner 10). 6.6 Screw the two lids back onto the ClimaRad ventilation-unit. [1]. 6.7 Place the heat-reflective hood back onto the ventilation-unit [2].
Page 1 and 2: Version 2010.001 EN Instructions fo
Page 3 and 4: Index: Index Step 1. Determining th
Page 5 and 6: Figure 1E: Measures Tandem window-s
Page 7 and 8: Step 3. Drilling the inner leaf of
Page 9 and 10: 4-1C 4-1D 4-1E 1 lekrand onder ! 2X
Page 11 and 12: 4-2D 4-2E 4-2F 1 2X lekrand onder !
Page 13: Step 5. Attach wall plates and radi
Page 17 and 18: 7F 7G 7H adjust 2X turn adjustment
Page 19 and 20: 9A 9B 9C 9D main switch 9.1 Close t
Page 21: 10E 10.5 B Connecting the in-betwee

Installatie instructie horizo... - Climarad

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?