Installatie instructie horizo... - Climarad

General information
Requirements for installation
Wall height of at least 650 mm (only in special cases with a minimal
window-sill a lower wall height (> 625 mm) may suffice).
Inner leaf of cavity wall must be strong enough to support the
reclinable radiator.
Rigid and strong wall construction for attachment of the radiatorsupports.
No plumbing pipes or steel constructions in the wall where airducts
will be drilled.
The ClimaRad must be able to blow out air upward unhindered.
At lower wall heights the window-sill may not protrude beyond the
frontside of the ClimaRad ventilation-unit. Therefore the window-sill
may not be deeper than approx. 104 mm (measured from the inside
wall surface, see figure 1B).
The outer wall must be reachable to install and maintain the
external duct-grills.
Tools and fixing materials
ClimaRad drilling template.
Drill Ø 112 mm, heavy drill suited for the wall to be drilled
Stone/concrete drill bit Ø 6 mm.
Stone/concrete drill bit Ø 10 mm.
Levelling rod.Pencil.
Spanners 10 mm, 13 mm.
Extension set socket 10.
PUR-spray.
Battery-driven drill with bits.
Cross-head screwdriver.