DUPREX 5000 Series RF INSTALLATION GUIDE - Galaxy Control ...

More documents

Recommendations

Info

Setup / Config mode operation and channel selection How to set the channel: 1. While Central and Remote units are still powered up on the bench, check dip switches 2,3,4 to make sure they are set to the required address. Switches 2,3,4 are all Off for the default channel 0 (zero). 2. On the Remote unit, move DIP switch 1 to the Service / Config (ON) position. a. The unit will reset. b. The Amber com led will flash momentarily, then go dark. c. The diagnostic LED will flash Red twice. d. The diagnostic LED will flash green on and off about once per second. The Remote unit is now in Setup mode. 3. On the Central unit, move DIP switch 1 to the Service / Config (ON) position. a. The unit will reset. BENCH TEST UNITS - Configuration Mode b. The Amber com led will flash rapidly on both the Central and Remote units. c. The diagnostic LED will flash green on and off about once per second. The addresses selected by the DIP switches will be loaded into memory. Make sure Central and Remote units are set to the SAME address! ©2005 Cypress Computer Systems,Inc. • www.cypressworld.com 2/18/05 Page 10
The RF units are capable on operating on six different “Channels”. Units on different channels can operate in the same area with minimal interference to each other. Channel selection can be made in the field. If necessary, channel selection should be initially made while the units are together on a bench, so operation can be verified. Units are shipped from the factory with a default channel setting of 0 (zero). In some cases where multiple units are part of the same original order, different channel assignments may be made for different pairs of units. A sticker will be present on the unit to indicate the factory setting. If only one pair of units are being used, the default setting should be adequate and changing channels should not be necessary. Here follows a description of the Setup / Config mode. Setup / Config mode: BENCH TEST UNITS - Configuration Mode By setting DIP switch 1 to the ON position, the unit is placed in Setup / Config mode. This switch change can be made at any time. When the switch position is changed, the unit will reset and restart in the new mode. This is helpful for setup and diagnostic purposes. The Setup / Config mode has 2 primary functions: 1. Places the units in rapid polling sequence to allow troubleshooting and setup of the communication link. 2. Reads and saves the RF channel address from the DIP switch setting. The Duprex RF units use a quiet protocol when operating in normal mode. Communication between the Central and Remote unit only occurs when an event requires data transmission or contact needs to be made to maintain supervision. The RF channel remains quiet most of the time. During setup or troubleshooting it may be necessary to observe the communication link between the Central and Remote units. The rapid polling used in the Setup / Config mode can help indicate whether the units can “See” each other. ©2005 Cypress Computer Systems,Inc. • www.cypressworld.com 2/18/05 Page 11
Page 1 and 2: DUPREX 5000 Series RF INSTALLATION
Page 3 and 4: DIP Switch Settings- Quick Referenc
Page 5 and 6: The Cypress Duprex RF is the newest
Page 7 and 8: The Duprex RF package should contai
Page 9: Initial power up Plug in the Remote
Page 13 and 14: Mounting the units. A site evaluati
Page 15 and 16: The other mounting method utilizes
Page 17 and 18: Plastic Nut With the units physical

DUPREX 5000 Series RF INSTALLATION GUIDE - Galaxy Control ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?