ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Assembly<br />
Cutting/Drilling Top Foil<br />
Determine top foil length using charts or by laying foils alongside wire. IMPORTANT! Confirm that you are using the<br />
correct <strong>unit</strong> size worksheet. Be sure to lay foils, lower <strong>unit</strong>, and leg kit alongside stay to confirm length before cutting.<br />
Use tape to mark foil. Cut foil to length.<br />
Tool: hacksaw<br />
Trim Cap Holes<br />
Cut off this end with trim cap hole. Hole is<br />
only used with full length 78 3 /4" (2000 mm)<br />
foil as top foil.<br />
Foil screw holes<br />
for connector<br />
Deburr inside edge using a file.<br />
Tool: rat-tail file<br />
Label top foil and identify which end will be<br />
at the top when installed. You will be drilling<br />
each side near the top.<br />
Lay top foil alongside cutoff piece. Use<br />
locking pliers to clamp foils together at the<br />
interior flat surfaces opposite the<br />
sail grooves.<br />
Use a flat metal object (i.e. metal ruler) to<br />
scribe lines on one side of foil. Leave foils<br />
clamped for drilling.<br />
Top Foil<br />
Tools: straight edge, locking pliers<br />
<strong>ESP</strong> Unit 2, 3 11