ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
ESP Jib REEfing & fuRling unit 1, 2, 3 - Harken
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Assembly<br />
Cutting/Drilling Top Foil<br />
1. Identify special length top foil with trim<br />
cap holes.<br />
Trim Cap Holes<br />
2. Slide top foil and 2 m foils and<br />
connectors onto wire.<br />
2a. Load connector so cutouts for<br />
bushings are facing up towards<br />
the top of stay.<br />
Note: On top foils under 12" (300 mm),<br />
load upper connector so that the cutouts<br />
for bushings face down towards the<br />
bottom of the stay.<br />
2b. Load onto wire from top and/or<br />
bottom.<br />
a. Cutouts<br />
b. Top of Stay<br />
3. Make sure that special length top foil<br />
with trim cap holes is at top of stay.<br />
Trim cap holes<br />
<strong>ESP</strong> Unit 2, 3 13
Change language