Manual_M50LTAT-52 - Auto Service Praxis

8.2 VEHICLE POSITIONING
• Stop slip plates by using the check pin (models “AT” and “LTAT”).
• Place the vehicle at the centre of the platform and check that it doesn’t slide out.
• Check that all stopping devices are operating.
8.3 LIFTING
• Set the main switch (12) to position 1 and press the UP button (7) to lift the vehicle to the
required level.
8.4 STANDING
• To let the lift stand, release the UP button and press the safety down button (5) till the
required position is reached. This operation activates the beeper and a few seconds later, the
lift goes in safety.
8.5 LOWERING
• Press the DOWN button (8) to carry out lowering .
The lift will raise for release the mechanical safety locks and then it will descend to a safety
height of about 400 mm.
Be sure the safety area is free of people and objects, then press the SAFETY DOWN button
(5) that activate the beeper and a few seconds later, the final descent.
Warning : engage the mechanical safety locks when the vehicle is left on the
runways for long periods (ex. during the night)
8.6 LIFT TABLE OPERATION
Turn the selector (11), on the front control desk, to utilize the lift table.
Adjust auxiliary lift platform extensions according to vehicle to lift
Place the rubber blocks under the picking point at the car
LIFTING
Press UP button (7) to lift vehicle to the required level
LOWERING
Press DOWN button (8), the lift will raise for a while to desengage the mechanical safeties. the lift
stops at about 130 mm. Put extension inside the table, Then press the safety down button (5), that
activates the beeper and a few seconds later, the final lowering.
before the lowering, make sure that the runways extensions are pushed back.
Damage caused to the lift, produced because of no observing the rules here
indicated, absolve the manufacturer from liabilities.