Installation and operating instructions - Haas + Sohn

More documents

Recommendations

Info

No.: Description Cable harness 3 Mains plug / mains filter 5 Electric ignition 6 Screw conveyor motor 7 Induced draught 8/9 OC 35/36 Flue gas temperature sensor 37/38 Flame temperature sensor 39/40 Room temperature sensor 41/42 Bottom flame temperature sensor 43/44 Door contact switch 48-50 Flue gas fan rotation speed F1 Fuse T 3,15A ignition, induced draught fan, screw conveyor motor F2 Fuse T 3,15A reserve F3 Fuse T 0,315A operator console 34
15. Guarantee General HAAS + SOHN gives the purchaser a guarantee within the context of the legislation. The two-year guarantee period commences on the date of the actual handover. The invoice is to be submitted as proof. Guarantee guidelines If a defect occurs in your device within the guarantee period, HAAS + SOHN will correct (improve) this defect in the shortest possible time or optionally replace the defective item. Cancellation of the contract/a price reduction is excluded in so far as this exclusion does not conflict with legislation. Only replacement parts that are expressly authorised or offered by the manufacturer may be used. We would like to point out that our customer service offices are also available on the usual terms and conditions at any time after the expiry of the guarantee. We reserve the right to make technical changes. HAAS + SOHN gives no guarantee for damage to or defects in devices or parts there of that have been caused by: Changes to the subject of the purchase that are connected with normal wear and tear (fire clay, Vermiculite, grate, glass ceramics and seals etc.), incorrect operation (e.g. overheating), overloading, neglect and changes without the consent of HAAS + SOHN are excluded from the guarantee. Errors in the installation and connection of the device, insufficient or too-strong chimney draught, incorrectly carried out repair work or other, in particular subsequent, changes to the heating appliance or flue gas pipework (stove pipe and chimney), use of unsuitable fuels, incorrect operation; overloading the devices (see the manufacturer’s operating instructions), wear on the parts made of iron or fire clay directly exposed to the flames, in so far as they are not covered by the guarantee (1a), incorrect handling, insufficient care, the use of unsuitable cleaning agents. Complaints Please address any complaints only to your specialist dealer. Here you must state the type and manufacturer’s numbers of your stove. You will find this information on the type plate of the device (on the back of the device). Instructions for ordering replacement parts When ordering replacement parts we would ask you to state the full type and manufacturer’s numbers of your pellet stove. You will find this information on the type plate of the device (inside the cover of the storage container) and on the first page of these instructions. If there is no reference to type or manufacturer’s number in this place, place enter them there. Then you will always have all the important information to hand. Please also note the drawings and tables in these instructions. Here you will find the correct descriptions of the required replacement parts. Attention! The heating appliance must not be modified! Only replacement parts that are expressly authorised or offered by the manufacturer may be used. If necessary, please contact your specialist dealer. 35
Page 1 and 2: Art. no. 0551708009031 V12 H27 Pall
Page 3 and 4: Congratulations! You are the owner
Page 5 and 6: Floor protection The floor is to be
Page 7 and 8: In the event of a large difference
Page 9 and 10: 6.2. Information screens 6.2..1 Inf
Page 11 and 12: Important: Your HAAS+SOHN Pelletto
Page 13 and 14: etween the relevant switch on and s
Page 15 and 16: 8.6. Cleaning the flue gas passes a
Page 17 and 18: Pallazza: 517.08 C, ST, 532.08 C Pa
Page 19 and 20: The pellet stove’s electrical fus
Page 21 and 22: 1 = Combustion chamber cladding, le
Page 23 and 24: 557 540 276 115 Figure 20: Dimensio
Page 25 and 26: 5. Shutoff flue gas temp. in Heatin
Page 27 and 28: combustion chamber” instruction,
Page 29 and 30: Fire goes out 1. Storage container
Page 31 and 32: Figures 23: Replacement parts Palla
Page 33: 14. Circuit diagram 33

Installation and operating instructions - Haas + Sohn

Create successful ePaper yourself

Delete template?

Save as template?