Experiment 5 â Coupler Design.

More documents

Recommendations

Info

Figure 10 - Mirror the strip. 4. Add the mirrored strip to the original strip. 5. Mirror the new strip with a normal plane normal (0, 1, 0), asshownin Figure 11. 18
Figure 11 - Mirroring again the strip. 6. Create four waveguide ports at each end of a strip line to perform the S-parameters calculation. An example of the first port location definition is shown in Figure 12. 19
Page 1 and 2: Experiment5—CouplerDesign. Dr. H
Page 3 and 4: 3. For a 20 dB three sections edge
Page 5 and 6: Forward wave 1 2 Through wave Sampl
Page 7 and 8: 1+C Z 0e = Z 0 1 − C , (2) r 1
Page 9 and 10: Because of the symmetry of the stru
Page 11 and 12: SSub SSUB SSub1 Er=4.7 Mur=1 B=0.32
Page 13 and 14: Figure 3 - Defining the first strip
Page 15 and 16: Figure5-Pickingthefaceoftheendofthe
Page 17: 1. Add the curved edge to the first
Page 21 and 22: 4.2.3 Calculating the Even and Odd
Page 23 and 24: Press on the ’Define Pins...’ b
Page 25 and 26: Figure 19 - Odd mode definition. 7.
Page 27: 4.4 Final Report Requirements 1. At

Experiment 5 â Coupler Design.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Experiment 5 â Coupler Design.