Experiment 5 â Coupler Design.

More documents

Recommendations

Info

w, the separation of S and the length of L. Figure 14 display the lines. Figure 14 - Model of 2 microstrip coupled lines. 4. Define a waveguide port and check the multipin box in the ’Mode setting’, as shown in Figure 15. Figure 15 - Defining the multipin port. 22
Press on the ’Define Pins...’ button and define potentials by pressing ’Add...’. Choose the number of the mode as ’1’, the potential as ’Positive’ and the location as ’Picked’, as shown in Figure 16. Figure 16 - Defining a potential. Press ’OK’ and select one of the planar port faces. Add another potential, also positive and pick the other port face. Figure 17 shows the potentials definition for even mode. Figure 17 - Even mode definition. 5. After the port definition, press with the right key of the mouse on ’port1’ from the ’Ports’ folder from the navigation tree and tree ’Info..’, 23
Page 1 and 2: Experiment5—CouplerDesign. Dr. H
Page 3 and 4: 3. For a 20 dB three sections edge
Page 5 and 6: Forward wave 1 2 Through wave Sampl
Page 7 and 8: 1+C Z 0e = Z 0 1 − C , (2) r 1
Page 9 and 10: Because of the symmetry of the stru
Page 11 and 12: SSub SSUB SSub1 Er=4.7 Mur=1 B=0.32
Page 13 and 14: Figure 3 - Defining the first strip
Page 15 and 16: Figure5-Pickingthefaceoftheendofthe
Page 17 and 18: 1. Add the curved edge to the first
Page 19 and 20: Figure 11 - Mirroring again the str
Page 21: 4.2.3 Calculating the Even and Odd
Page 25 and 26: Figure 19 - Odd mode definition. 7.
Page 27: 4.4 Final Report Requirements 1. At

Experiment 5 â Coupler Design.

Create successful ePaper yourself

Delete template?

Save as template?

Experiment 5 â Coupler Design.