Pilatus PC-21 Depron-Version - HT-Modellbau

3) Install rod pins on levers of servos. Pass rods through bowdens in fuselage. Install servos into plywood plate in
fuselage from below. Connect rods with servos and levers of rudder and elevator.
4) Screw the motor with connected regulator to the bulkhead, pass it through the opening in bulkhead into fuselage.
Put plastic motor hood on and check if shaft of the carrier passes through bonnet center and modify position of
motor if necessary. Stick motor cover either to fuselage or fix it to inside spruce braces of fuselage using two
screws.
6