User Manual

3 Close the access door, being careful to neatly align the cable to the left.
Note: You may choose to completely remove the access door and store it.
Disabling fax and e-mail functions prior to setup
The indicator light blinks until you set up Fax and E-mail. To disable the blinking light, follow these steps:
Note: Before completing these instructions for a printer on a network, make sure the fax cables are connected.
1 Touch Menus.
2 Touch Settings.
3 Touch General Settings.
4 Touch the left or right arrow next to Run initial setup to select Yes, and then touch Submit.
Submitting changes appears.
5 Turn the printer off, and then turn the printer back on.
6 From the printer control panel, touch your language.
7 Touch your country or region, and then touch Continue.
8 Touch the left or right arrow to select your time zone, and then touch Continue.
9 Touch Fax and E-mail to deselect them, and then touch Continue.
Note: You can use these same steps to enable Fax and E-mail.
Additional printer setup
42