Hurlcon Gas Fired Hot Water Boiler H120 & H150 ... - Hurlcon Heating
Hurlcon Gas Fired Hot Water Boiler H120 & H150 ... - Hurlcon Heating
Hurlcon Gas Fired Hot Water Boiler H120 & H150 ... - Hurlcon Heating
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8.0 <strong>H120</strong> – <strong>H150</strong> WIRING DIAGRAM<br />
8.1 MODEL <strong>H120</strong> – <strong>H150</strong> WITH HEATSAVER<br />
8.2 55 – 90 DEGREE SETTING & THERMOSTAT SELECTION<br />
By changing the jumper position the boiler<br />
maximum setpoint can be altered from 90° to<br />
55°. This should be done prior to start up,<br />
however if this is done after power has been<br />
applied to the boiler un- plugging and<br />
reconnecting power will ensure the correct<br />
setting. This is located on the rear of the<br />
Genus control board at the front of the <strong>Boiler</strong>.<br />
If the optional <strong>Hurlcon</strong> Genus room<br />
thermostat is used the thermostat selector<br />
switch is required to be set to the correct<br />
position. This switch is located at the rear of<br />
the electrical panel within the boiler cabinet as<br />
shown.<br />
<strong>H120</strong> –<strong>H150</strong> <strong>Hot</strong> <strong>Water</strong> <strong>Boiler</strong>s page 18
Change language