Vol.45 - Protel

Ultra-light handpiece
with phenomenal heat recovery
RoHS
LEAD
FREE
ANTI
STATIC
NICHROME
Heater
temperature
CONTROL
400 400
39%
Operation efficiency increased by
over our conventional soldering stations.
300
200
100
(˚C)
0
Tip Temperature Stability
RX-802AS
Amount of time required :
10 min.10 s.
300
200
100
(˚C)
2 4 6 8 10 12 14 (min.)
0 2 4 6 8 10 12 14 (min.)
This data refers to the measurement
of lead-free solder melted on a 20mm
land melting 35 points in succession.
Tip Temperature Stability
RX-852AS
Amount of time required :
7min. 20 s.
The RX-852AS has the advantage of
faster soldering and tip temperature
stability, compared to the RX-802AS.
Anti Static Model
Lead-free Applicable
Excellent heat recovery (PAT.)
Excellent heat recovery has been
achieved by combining a 150W compact
high output heater with a highsensitivity-sensor.
It makes difficult
work that requires high heat capacity,
easy.
Fastest in its class
Reaches 350°C in only 14 seconds.
(Only 6 seconds when using
RX-80HRT tips)
Easy to replace tip without
using tools (PAT.)
Slide-change tip. No tools or heat
resistant pads needed.
Heater and Sensor All-in-one Tips
All-in-one tips with the heater and sensor built in making maintenance
and tip changing as easy as possible.
Extra Thick Tip Coating for Lead-free Soldering
All tips with extra thick coating to slow erosion
caused by the use of lead-free solder.
RX-80HRT tips can also be used
42 shapes of tip available, including the 26
optional tips for the RX-802AS. see P70
High/Low Temperature Alarm
An alarm sounds (to alert the user) when the temperature goes
outside (above or below) the maximum or minimum temperature
settings. High/low setting range 3°C–100°C.
Intelligent Sleep Function (PAT.)
Soldering Iron Stand ST-20,
Tip Holder ST-20C included
Tips Not Included.
Tips Sold Separately.
Up to a 22mm 2 copper
wire can be soldered.
Slim tips now added to line-up
RX-852AS
Automatically lowers the tip temperature when inactive for a preset
period of time, preventing overheating. User definable preset time.
(Can be used in conjunction with Shutdown function.)
Sleep Release Function (PAT.P)
Sleep mode can be exited (at any time) by bringing the tip into
contact with the wet sponge to cause temperature fluctuation.
(Effective when temperature is set above 100°C)
Intelligent Sleep Function
Mode : Select sleep function on/off
(CT) Sleep start time
(SST) Sleep setting temp.
(DIF) Sensitivity
*Each parameter can be set
Soldering tip temperature
Operation
Power ON
DIF
DIF
How to Change the Soldering Unit Tip
CT
SST
Set temperature
Sleep start
Time
To remove the soldering unit tip, slide the lever in the direction of
the arrow. The tip will then protrude from the handpiece and can be
removed easily by holding and pulling the plastic housing of the integrated
tip/heater.
Slide lever
Tip
Slim tips now added to line-up.
Makes working multi-layer PCBs possible.
Hold here to remove
18