Vol.45 - Protel

6 seconds to set temperature
The ultimate solution for lead-free soldering
Anti Static Model
Lead-free Applicable
ST-20 Soldering Iron
Stand Included
RoHS
Temperature Controlled
StationRX-802AS
lead-free soldering
LEAD
FREE
ANTI
STATIC
NICHROME
Heater
temperature
CONTROL
Excellent heat recovery
(PAT.)
Compact, high output heater
(72W) combined with a high
sensitivity sensor means there
is almost no temperature fluctuation
during heavy load continuous
operation.
Fastest in its class
Reaches set temperature in just 6 seconds after turning power on.
Turn on and start work immediately. No wasted time.
Easy to replace tip without using tools
With the new slide-change tip there
is no need for heat-resistant pads or
tools when changing the tip. (PAT.)
All-in-one tip design
Heater and sensor included in the tip
making maintenance and changing tips easy.
Anti-oxidation tip (PAT.)
Tips designed with fine solder coated grooves
to stop oxidation. (RX-80HRT-BM only)
50 100 150 200 250 300 (sec.)
Reduced heat-up of soldering unit grip
Newly designed thermal insulation soldering unit construction (PAT.P)
to reduce heat transfer to the grip.
(˚C)
350
300
250
200
150
100
50
0
During work
Even during continuous heavy load work
the temperature of the soldering iron tip
remains close to the set temperature.
Measurement method
A generous amount of lead-free solder
(ø1X20mm length) applied to a land of 6mm
diameter dissolving 40 points in succession.
Thick iron plating for lead-free soldering
All tips with thick iron plating to slow erosion caused by lead-free
soldering.
High/Low Temperature Alarm
An alarm sounds (to alert
Alarm characteristics
the user) when the temperature
goes outside (above
L
Lower limit temp.
or below) the maximum or
minimum temperature settings.
High/low setting range
3˚C–100˚C.
Set temperature
Upper limit temp.
H
Intelligent Sleep function (PAT.)
The control unit automatically lowers the temperature when inactive
for a preset period of time. This can also be done manually by pressing
and holding the key for 1 second. The sleep function can be
used in conjunction with the shutdown function.
Intelligent Sleep Function
Mode : Select Sleep function ON/OFF
(CT) Sleep start time
(SST) Sleep setting temp.
(DIF) Sensitivity
Each parameter can be set.
Soldering tip temperature
Operation
DIF
DIF
CT
SST
Set temperature
Sleep start
Power ON
Time
820