1992-1996 Dodge Viper RT/10 - Paxton Superchargers
1992-1996 Dodge Viper RT/10 - Paxton Superchargers
1992-1996 Dodge Viper RT/10 - Paxton Superchargers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 2<br />
OIL FEED<br />
2. OIL FEED<br />
A. Remove the oil pressure sender from the<br />
front passenger side of the engine directly<br />
above the oil filter.<br />
B. Install the 1/8"NPT TEE in the oil sender<br />
hole. Leave the TEE pointed up. Install the<br />
1/8"NPT x -4 90° fitting in the top of the<br />
TEE. Install the oil pressure sender in the<br />
front hole in the TEE and re-attach the electrical<br />
plug. (See Fig. 2-a.)<br />
C. Temporarily cover one end of the oil feed<br />
line and protect it from debris until connecting<br />
it to the supercharger.<br />
D. Connect the open end of the oil feed line to<br />
the -4 fitting. Use tie-wraps to secure the<br />
line and protect it from kinking, abrasion<br />
and high heat areas.<br />
***IMPO<strong>RT</strong>ANT***<br />
Use clean engine oil on the pipe threads. Teflon tape<br />
and sealant is NOT recommended as it might loosen<br />
and cause blockage of the small oil feed orifice resulting<br />
in supercharger failure.<br />
Fig. 2-a<br />
2-1<br />
P/N: 4809646<br />
©2006 <strong>Paxton</strong> Automotive<br />
All Rights Reserved, Intl. Copr. Secured<br />
17FEB06 v2.0 92-96<strong>Viper</strong>(4809646v2.0)
Change language