USER AND INSTALLATION MANUAL - KACO new energy, Inc.

More documents

Recommendations

Info

3. Turn off the DC and AC switches. 4. Put the key into the cabinet’s locks and open it. – The handle flips up then turns the handle. Page 48
11. OPERATING STARTUP INSTRUCTIONS Part 1 Part 3 Part 2 Inside of the Inverter After installation and electrical connection, the Inverter will be ready for operation. Follow these instructions. • Check that the switches in the part1 are turned on. If not, turn on the switches. • Check that the switches in the part2 are turned on. If not, turn on the switches. • Turn on the switch in the part3. • Close the cabinet doors. • Turn on the AC and DC, and disconnect switches on the left cabinet door. Page 49
Page 1 and 2: XP100U-H2/ XP100U-H4 XP83U-H6/ XP90
Page 3 and 4: CAUTION! "CAUTION" indicates a haza
Page 5 and 6: CONTENTS IMPORTANT SAFETY INSTRUCTI
Page 7 and 8: 2. SAFETY Appropriate Usage Any oth
Page 9 and 10: DANGER! During operation, high volt
Page 11 and 12: Regulations concerning the preventi
Page 13 and 14: 3. THE BLUEPLANET INVERTER OVERVIEW
Page 15 and 16: Left, Right and Back Page 15
Page 17 and 18: 4. UNPACKING This section describes
Page 19 and 20: Minimum Workspace Requirements The
Page 21 and 22: Foundation L-bracket surface mount
Page 23 and 24: 6. CONNECTING THE CONDUIT In this s
Page 25 and 26: Using the bottom panel for con
Page 27 and 28: Connection Area D D A: AC Connectio
Page 29 and 30: Grid Connection The inverter is con
Page 31 and 32: PV Connection PV Array is connected
Page 33 and 34: 2 300kcmil All 194 (90℃) copper w
Page 35 and 36: UDIO - User digital input output te
Page 37 and 38: UDIO - User digital output (relay c
Page 39 and 40: RS485-2 Target port figure Connect
Page 41 and 42: PT1000 (external temperature) senso
Page 43 and 44: To get the most accurate data from
Page 45 and 46: 9. COMMISSIONING DANGER! Electric s
Page 47: 10. OPENING THE INVERTER DANGER! El
Page 51 and 52: If no fault is present the inverter
Page 53 and 54: Operating start Fault Fault Reset D
Page 55 and 56: ANALOG INTERFACE PARAMETERS Paramet
Page 57 and 58: 13. FAULTS & WARNINGS When a proble
Page 59 and 60: Inv. Over Voltage F10 Over voltage
Page 61 and 62: 14. MAINTENANCE Insulating gloves m
Page 63 and 64: Time intervals for maintenance work
Page 65 and 66: PEBB fan assembly 1. Switch off the
Page 67 and 68: Fault Code Message Warning Descript
Page 69 and 70: F33 F34 F40 F41 F42 F43 F44 Grid Un
Page 71 and 72: Maximum continuous output power 100
Page 73 and 74: 7. Interface Specification Display
Page 75 and 76: 17. CONFIGURATION THE INVERTER BLO
Page 77 and 78: Page 77
Page 79: Page 79

USER AND INSTALLATION MANUAL - KACO new energy, Inc.

Create successful ePaper yourself

Delete template?

Save as template?