USER AND INSTALLATION MANUAL - KACO new energy, Inc.

More documents

Recommendations

Info

Safety Instructions DANGER! High voltages are present in the live components of the low voltage grid. Death may result from burns and electric shock. Do not touch the live components of the Inverter or low-voltage grid. Pay close attention to all safety precaution measures regarding the low voltage grid. Page 8
DANGER! During operation, high voltages are present in the Inverter. Death may result from burns and electric shock. Before commencing work on the Inverter disconnect completely and ensure that the device will not be accidentally energized. Ensure that no voltage is present. Ground and short-circuit. Cover any nearby live parts. DANGER! Normally grounded conductors may be ungrounded and energized when a ground-fault is indicated. Risk of electric shock. Test before touching. Contact customer support for information at KACO new energy, Inc. +1 (415) 931-2046. WARNING! Failure to follow the manual, the operating instructions and the safety precautions may lead to severe injury from electrocution. All work on the Inverter may only be done as described in this manual and must be performed by qualified personnel. Pay attention to all safety instructions. Follow all operating instructions. If problems occur when performing the work described here, contact the customer support department at KACO new energy Inc. +1 (415) 931-2046. Page 9
Page 1 and 2: XP100U-H2/ XP100U-H4 XP83U-H6/ XP90
Page 3 and 4: CAUTION! "CAUTION" indicates a haza
Page 5 and 6: CONTENTS IMPORTANT SAFETY INSTRUCTI
Page 7: 2. SAFETY Appropriate Usage Any oth
Page 11 and 12: Regulations concerning the preventi
Page 13 and 14: 3. THE BLUEPLANET INVERTER OVERVIEW
Page 15 and 16: Left, Right and Back Page 15
Page 17 and 18: 4. UNPACKING This section describes
Page 19 and 20: Minimum Workspace Requirements The
Page 21 and 22: Foundation L-bracket surface mount
Page 23 and 24: 6. CONNECTING THE CONDUIT In this s
Page 25 and 26: Using the bottom panel for con
Page 27 and 28: Connection Area D D A: AC Connectio
Page 29 and 30: Grid Connection The inverter is con
Page 31 and 32: PV Connection PV Array is connected
Page 33 and 34: 2 300kcmil All 194 (90℃) copper w
Page 35 and 36: UDIO - User digital input output te
Page 37 and 38: UDIO - User digital output (relay c
Page 39 and 40: RS485-2 Target port figure Connect
Page 41 and 42: PT1000 (external temperature) senso
Page 43 and 44: To get the most accurate data from
Page 45 and 46: 9. COMMISSIONING DANGER! Electric s
Page 47 and 48: 10. OPENING THE INVERTER DANGER! El
Page 49 and 50: 11. OPERATING STARTUP INSTRUCTIONS
Page 51 and 52: If no fault is present the inverter
Page 53 and 54: Operating start Fault Fault Reset D
Page 55 and 56: ANALOG INTERFACE PARAMETERS Paramet
Page 57 and 58: 13. FAULTS & WARNINGS When a proble
Page 59 and 60:
Inv. Over Voltage F10 Over voltage
Page 61 and 62:
14. MAINTENANCE Insulating gloves m
Page 63 and 64:
Time intervals for maintenance work
Page 65 and 66:
PEBB fan assembly 1. Switch off the
Page 67 and 68:
Fault Code Message Warning Descript
Page 69 and 70:
F33 F34 F40 F41 F42 F43 F44 Grid Un
Page 71 and 72:
Maximum continuous output power 100
Page 73 and 74:
7. Interface Specification Display
Page 75 and 76:
17. CONFIGURATION THE INVERTER BLO
Page 77 and 78:
Page 77
Page 79:
Page 79
show all

USER AND INSTALLATION MANUAL - KACO new energy, Inc.

Create successful ePaper yourself

Delete template?

Save as template?