Falcom STEPP Configurator Software instructions

More documents

Recommendations

Info

<strong>STEPP</strong>-CONFIGURATOR VERSION 2.1 Figure 6.2: The car list. Figure 6.3: Setting up a temporary connection. connection setup, as seen in Figure 6.3. When setting up a temporary connection, either choose a car from the car list or type in the network number. It is possible to communicate to the Stepp device via SMS messages or via a data call. When connecting using SMS messages, the SMS password might be necessary (see Section 3.1.1). When connect using a data call, it is necessary to specify wether or not to hang up after the operation is ready. Temporary connections can be used for the operations listed below. • Reading and applying configuration. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 29
<strong>STEPP</strong>-CONFIGURATOR VERSION 2.1 • Acquiring history (data call only). • Clearing history. • Setting the outputs. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 30
Page 1 and 2: This document is available at HTTP:
Page 3 and 4: STEPP-CONFIGURATOR VERSION 2.1 7.1.
Page 5 and 6: STEPP-CONFIGURATOR VERSION 2.1 0 Ch
Page 9 and 10: STEPP-CONFIGURATOR VERSION 2.1 Figu
Page 13 and 14: STEPP-CONFIGURATOR VERSION 2.1 radi
Page 19 and 20: STEPP-CONFIGURATOR VERSION 2.1 when
Page 23 and 24: STEPP-CONFIGURATOR VERSION 2.1 GPIO
Page 29: STEPP-CONFIGURATOR VERSION 2.1 Figu
Page 33 and 34: STEPP-CONFIGURATOR VERSION 2.1 dd'm
Page 35 and 36: STEPP-CONFIGURATOR VERSION 2.1 1-4:
Page 37 and 38: STEPP-CONFIGURATOR VERSION 2.1 RING
Page 39 and 40: STEPP-CONFIGURATOR VERSION 2.1 Any
Page 41 and 42: STEPP-CONFIGURATOR VERSION 2.1 If a
Page 45 and 46: STEPP-CONFIGURATOR VERSION 2.1 &CNF
Page 47 and 48: STEPP-CONFIGURATOR VERSION 2.1 &CNF

Falcom STEPP Configurator Software instructions

Create successful ePaper yourself

Delete template?

Save as template?