download - Knoll

EW3 Worksurfaces
Blended Corner&Peninsula
Equity
description A B C D pattern no. list price
Blended corners 24 36 60 24 EW3BS3660S( )G $676.
24 36 72 24 EW3BS3672S( )G 719.
24 48 60 24 EW3BS4860S( )G 740.
24 48 60 30 EW3BS4860D( )G 749.
24 48 66 24 EW3BS4866S( )G 774.
24 48 66 30 EW3BS4866D( )G 792.
24 48 72 24 EW3BS4872S( )G 806.
24 48 72 30 EW3BS4872D( )G 839.
24 60 36 24 EW3BS6036S( )G 676.
24 60 48 24 EW3BS6048S( )G 740.
24 60 48 30 EW3BS6048D( )G 745.
24 66 48 24 EW3BS6648S( )G 774.
24 66 48 30 EW3BS6648D( )G 777.
24 72 36 24 EW3BS7236S( )G 719.
24 72 48 24 EW3BS7248S( )G 806.
24 72 48 30 EW3BS7248D( )G 820.
30 48 60 24 EW3BD4860S( )G 745.
30 48 66 24 EW3BD4866S( )G 777.
30 48 72 24 EW3BD4872S( )G 820.
30 60 48 24 EW3BD6048S( )G 749.
30 66 48 24 EW3BD6648S( )G 792.
30 72 48 24 EW3BD7248S( )G 839.
Blended peninsula (left handed shown) 60 48 24 – EW3BP6048S(R/L) 725.
72 48 30 – EW3BP7248D(R/L) 831.
Order Code
Example: EW3BS3672SLG, M42,
E, E
EW3B Blended worksurface
S 24 left depth
36 48 left width
72 72 right width
S 24 right depth
L Left side post covered
G Grommet
M42 Soft grey laminate
E Soft grey vinyl trim
E Grommet color
Specification Information
Specify laminate, vinyl trim, and
grommet colors when applicable.
All support bracketry must be
ordered separately.
Note:
If an edge grommet is not desired,
remove the ‘‘G’’ and deduct $20.
94
Application Notes
Blended worksurfaces are designed
to take the place of two adjacent
worksurfaces by blending them into
one top. The front of the
worksurface is curved to provide a
smooth transition to the next
attached worksurface.
Blended worksurfaces are handed
and may or may not cover a post on
either or both sides. Hand is
determined from the seated position.
Option suffixes for Blended corners
are as follows:
X=No posts covered
L=Left side post covered
R=Right side post covered
B=Both sides posts covered
Blended peninsulas are handed and
always cover one post. Hand is
determined from seated position.
Rounded end is 30 deep.
Blended peninsulas do not come
with grommets. Due to this, the
worksurface meeting the ‘‘c’’ side
will have a one-half grommet where
the return meets the peninsula.
Depth options are as follows:
S=24deep
D=30deep
Center support must be used for all
surfaces which exceed 48 in
length.