download - Knoll

Worksurface, blended double corner, curved cluster, corner
round
EW1, EW2 and EW3 profiles
Equity
description A B C pattern no. list price
Blended double corner 96 48 24 EW1BC9648G $696.
96 48 24 EW2BC9648G 696.
96 48 24 EW3BC9648G 904.
135° Curved cluster 36 24 – EW11353624G 613.
36 24 – EW21353624G 613.
36 24 – EW31353624G 796.
42 24 – EW11354224G 764.
42 24 – EW21354224G 764.
42 24 – EW31354224G 994.
48 24 – EW11354824G 876.
48 24 – EW21354824G 876.
48 24 – EW31354824G 1,139.
Worksurfaces and Tables
135° Curved cluster center core 36 – – EW1135C36 384.
42 – – EW1135C42 423.
48 – – EW1135C48 465.
Corner-round worksurface 24 – – EW1CR24 194.
24 – – EW2CR24 194.
24 – – EW3CR24 253.
30 – – EW1CR30 216.
30 – – EW2CR30 216.
30 – – EW3CR30 281.
Order Code
Specification Information
Application Notes
Example: EW1BC9648G, M42, E,
E
EW1BC Blened double corner
96 Width
48 Depth
G Grommet
M42 Soft grey laminate
E Soft grey edge
E Soft grey grommet
Specify laminate, vinyl trim, and
grommet colors where applicable.
Support bracketry must be ordered
separately.
Note:
If an edge grommet is not desired,
remove the ‘‘G’’ and deduct $20.
Double corner worksurface is
designed to take the place of two
adjacent corners by combining then
into one top.
48 deep sides are designed to cover
a post and cannot be panel wrapped.
Corner round worksurface is for
use in outside 90-degree
configurations only and is used to
transition two adjacent
worksurfaces.
Worksurfaces meeting either side of
the corner-round worksurface must
be extended on that end to avoid a
gap between worksurfaces.
Curved cluster worksurface is
used in 135-degree planning
configurations.
95