Kerio Control — Administrator's Guide - Kerio Software Archive

Configuration Assistant
Two Internet links with load balancing
If at least two Internet links are available, Kerio Control can divide traffic between both of
them:
1. On the first page of the wizard, select Two Internet links with load balancing.
2. Click Next.
3. Select two interfaces to be used as Internet links with traffic load balance.
For each link it is necessary to specify link weight, i.e. its relative throughput. The weight
of individual links indicates how Internet traffic is distributed among the links (it should
correspond with their speed ratio).
Example
You have two Internet links with connection speed 4 Mbit/s and 8 Mbit/s. You
set weight 4 for the first link and weight 8 for the other one. The total Internet
connection load will therefore be divided in the proportion 1:2.
4. Select mode:
• Automatic — the interface where Kerio Control detected the default gateway is
used. Therefore, in most cases the appropriate adapter is already set within this
step.
• Manual — you can change configuration of the default gateway, DNS servers, IP
address and subnet mask.
If the more IP addresses are set for the interface, the
primary IP address will be displayed.
• PPPoE — enter the username and password from your Internet provider.
5. Click Next.
6. Select the interface connected to the local network.
If multiple interfaces are connected to the local network, select the interface you are
currently using for connection to the Kerio Control administration.
7. Click Next.
8. Verify your configuration and click Finish.
You can check the result in section Interfaces. The Internet Interfaces group includes the
Internet links selected in the third page of the wizard.
22