Kerio Control — Administrator's Guide - Kerio Software Archive

Configuring network interfaces
3. Select PPPoE mode.
4. In the PPPoE Interface Properties dialog, type a new interface name.
5. Type the username and password.
6. Save the settings.
Configuring PPPoE tunnel
If this connection is used as a single Internet link, it is recommended to define PPPoE
connection in the Ethernet interface.
If you need to create another interface to the Internet, use these instructions:
1. In the administration interface, go to Interfaces.
2. Click Add → PPPoE.
3. In the PPPoE Interface Properties dialog, type a new interface name.
4. The Interface Group leave as it is.
You can change it later.
5. On tab Dialing Settings, select the interface.
If you set the interface to Any, Kerio Control will automatically select the
appropriate interface which will be used for connection.
6. Type the username and password from your provider.
7. Set time intervals in which the connection should be established persistently and when it
should be disconnected.
Out of these intervals, the link will demand manual dialing.
automatically after defined period of idleness.
The link can be hung up
Configuring PPTP tunnel
You need the following information from your provider:
• PPTP server hostname
• username and password for PPTP server access
1. In the administration interface, go to Interfaces.
2. Click Add → PPTP.
34