k9-classic-edp2 - car alarm

Wiring Diagram
Overview
The K9-CLASSIC-EDP2 is a 1-way system, including
two transmitters. The K9 may be upgraded to
2-way operation by using an optional Omega Echo
kit.
Status Lights
Valet
Switch
( ( (ECHO
(Optional)
System
Receive / Transmit
Module
K9-CLASSIC-EDP2
Status Light
Valet Switch
Starter Interrupt
socket and relay
Red
White
Orange 2-pin Connector
(-) Horn Honk - Brown/Black
(-) Parking Light - White/Black
Impact
Sensor
To Ignition
Switch
cut wire
To Starter
Main Wiring Harness Connector
(-) Starter Interrupt Output - Orange
(-) 2nd Channel Output (trunk release) - Gray
Ignition Power Input - Yellow
System (-) Ground - Black
To Constant (+) Power - Red
Secondary Wiring Harness Connector
(-) 3rd Channel Output - Pink
(-) Door Trigger Input - Green
(-) Hood Trigger Input - Blue
(+) Door Trigger Input - Violet
(+) Siren Output - Brown
(+) Parking Light Output - White
Interior Light Output - Green/Violet
(+ or -) Interior Light Input - Black/Red
15 AMP
10 AMP
10 AMP
Main
Harness
Secondary
8-Pin 5-Pin
Harness
Backup
Battery
Port
Slide-On Clip for
optional modular
Backup Battery
White 4-pin Connector
Auxiliary Sensor Port
Data Green - Prewarn
Port
Blue - Trigger
Black - Ground
Red - Power
Red 4-pin Connector
Power Doorlock Port
Pink - Unlock #2 Output
Blue - Unlock #1 Output
Relay Coil Power (pin)
Green - Lock Output
Coaxial Antenna Cable: Route end as
high as practical in vehicle, away from metal.
Note: May be removed if the optional 2-way Echo kit is used.
Page - 18 Page - 19