SERVICE MANUAL - kyocera

2DF
17. Slightly lift the bottom of the finisher and
insert the rail fixing plate into the finisher, and
then join them by inserting two M4 × 6
binding screws loosely.
Finisher
Rail fixing plate
18. Insert the guide rail into the rail fixing plate
and secure it using an M4 × 6 binding screw
at the position where the screw hole in it and
that in the rail fixing plate meet.
Note: When installing the switchback unit,
use screw hole a in the guide rail; when not
installing the switchback unit, use screw
hole b in the guide rail.
Rail fixing plate
M4 × 6
binding screw
Figure 1-3-46
M4 × 6
binding screws
Screw hole a
Screw hole b
Rail fixing plate
Guide rail
19. Adjust the position of the rail fixing plate so
that the gap between the plate and the floor is
approximately 8.0 mm, and then tighten the
two loosely fitted M4 × 6 binding screws.
Figure 1-3-47
M4 × 6
binding screws
Rail fixing plate
8.0 mm
M4 × 6
binding screws
1-3-28
Figure 1-3-48