SERVICE MANUAL - kyocera

2DF
3. Release the hook of the switchback unit by
lifting the release lever.
Switchback unit
Release lever
4. Fit the switchback unit to the finisher by
hanging the hook of the switchback unit on
the loosely fitted M3 × 8 binding screws.
5. Tighten the loosely fitted M3 × 8 binding
screws.
6. Secure the switchback unit using two M4 × 12
TP screws.
7. Close the switchback unit.
Figure 1-3-52
Hook
Hook
Finisher
Switchback unit
M4 × 12
TP screw
M4 × 12
TP screw
Figure 1-3-53
M3 × 8
binding screws
8. Remove the two screws from the cover of the
finisher.
Finisher
Screws
Figure 1-3-54
1-3-30