Weinig Tools - OERTLI Werkzeuge AG
Weinig Tools - OERTLI Werkzeuge AG
Weinig Tools - OERTLI Werkzeuge AG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Hydraulic clamping<br />
4 Hydraulic clamping<br />
4.1 <strong>Weinig</strong> Centrolock 534<br />
4.1.1 Safety<br />
The <strong>Weinig</strong> Centrolock 534 is a heavy-duty cutter.<br />
All the relevant safety regulations and the instructions in<br />
this operating manual must be closely followed in order<br />
to ensure safe use and handling of this tool.<br />
Please read these instructions through carefully before<br />
using the tool.<br />
4.1.2 Intended use<br />
The profile cutterhead is only approved for mechanical<br />
feed systems and is used for the following purposes:<br />
Planing and profiling work on solid wood (hard and soft<br />
wood) and wood substitutes.<br />
Applications: see technical data.<br />
Chapter 1 Safety must be read through<br />
carefully and observed before using the<br />
tool.<br />
534<br />
DOKW0066<br />
4.1.3 Special safety instructions for tool 534<br />
• Check that the profiled cutters are correctly seated in<br />
the serration.<br />
• Insert all cutters in the serration in the same position<br />
(distance from bottom of groove).<br />
• Leitz DoubleBack system:<br />
Max. blank height 60 mm for Z = 2<br />
Max. blank height 70 mm for Z = 4<br />
• The corresponding clamping ledge must be selected<br />
in accordance with the thickness of the profiled<br />
cutters (5, 6, 8 or 10 mm).<br />
• Blind lugs must be fitted to prevent the clamping<br />
ledges from bending when using profiled cutters<br />
which are more than 20 mm shorter than the<br />
clamping ledges.<br />
• The tool must always be fitted in the machine with<br />
anti-twist device.<br />
• The clamping pressure (300 bar) must be checked<br />
daily with the aid of a grease gun before starting up<br />
the machine.<br />
• Recommended grease: Shell Alvania Fett RL2.<br />
Tech. Dok. / WNW 850 02 / 02.2005.A / © MICHAEL WEINIG <strong>AG</strong> <strong>Weinig</strong> <strong>Tools</strong> 4-1