free flow users guide - PBportal.de

More documents

Recommendations

Info

3. Service your sir setup according to manufacturers recommendations Make sure to perform both maintenance procedures as needed. If you are unsure about performing the maintenance in any way at all please consult a paintball airsmith or send your gun to one of our service centers (we will gladly do it for free). Failure to maintain your Team Lockout Free Flow Autococker can result in malfunction that is not covered under out lifetime warranty. Troubleshooting If your Team Lockout Free Flow Autococker exhibits any of these problems feel free to use this troubleshooting guide to help solve your problem. The majority of problems with the gun are covered under our warranty. Feel free to send your gun to one of our service centers for factory certified service if you are not comfortable doing the service yourself or the problem can’t be fixed using this guide. Problem: Gun gets erratic or low velocity Solution: Make sure that the final input pressure to your Free Flow Autococker is between 300psi and 320psi. Make sure your secondary regulator is holding pressure (not building up pressure). Check paintballs for correct sizing to your barrel. Problem: Gun burps of fires every few shots Solution: Make sure your cocking rod is fully tightened and your rock regulator is adjusted properly. If they are, then make sure your sear spring (vertical spring inside of the Professional 45 Frame) is properly installed (resting on the back of the sear plate). If it is tehn check your pump arm length (you want the rear block to be loose on the body when the ram is gassed up). I fit is the correct length then follow the steps for checking the lug release in the Autococker manual – a small (1/8 turn or less) clockwise lug adjustment can be all you need. Problem: Trigger feels gritty or hard to pull Solution: Remove and service Professional 45 frame. Take the time to inspect the lug release surface. It should have a small dark mark on it but not a gritty edge. If you find a gritty edge on the lug release part of the sear – remove it and use some fine grit sandpaper (300 or higher) to smooth it out. Warranty Policy If your gun breaks from normal use we will cover most of the cost of repairing it for th life of the gun. We will cover any parts, including wearable parts, and any service needed to make your gun shoot like you want it to. We will not cover any shipping and handling charges incurred from improper use (i.e. throwing the gun, running it over with a car, diving into a concrete bunker, etc.). Ultimately we will fix your gun free of charge
(excluding shipping) if you do not modify it or break it from improper use. If you have any questions concerning this warranty please feel free to call us during normal business hours at (585) 924-9930. If you have any questions regarding the service of your Team Lockout Free Floe Autococker please email us at service@4freeflow.com or call us during normal business hours at (585) 924-9930. If you need to send your gun in for repair or otherwise, please use the address below. Be sure to include the following to expedite your service: 1. Return address where you want the gun returned. 2. Your name. 3. Note explaining the problem or service desired. 4. Daytime phone number (in case we have any questions). Authorized Service Centers Service Department Professional Paintball Supplies Inc. 160 School Street Victor, NY 14564
Page 1 and 2: This guide is designed to accompany
Page 3 and 4: This guide will teach you to mainta
Page 5: 9. You made need to make minor adju

free flow users guide - PBportal.de

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?