Taurus ELECTRO manual 472 ENG.pdf - Pipistrel

More documents

Recommendations

Info

84 TAURUS <strong>ELECTRO</strong> www.pipistrel.si REV. 0 Handling and maintenance Periodical cleaning of all outer surfaces with car shampoo Clean as you would clean your car starting at the top and working your way downwards using a soft sponge. Be careful not to use a sponge that was contaminated with particles e.g. mud, fine sand) not to grind the surface. While cleaning, do soak the surface and the sponge many, many times. Use a separate sponge to clean the bottom fuselage, as is it usually more greasy than the rest of the airframe. When pouring water over the airframe, be careful not to direct it over the wing-fuselage joining section, parachute rescue system straps and cover, pitot tube, tail static probe and motor covers. Always water the shampooed surfaces again before they become dry! Thereafter, wipe the whole of the aircraft dry using a drying towel, chamois or artificial leather skin. Also, clean the Mylar wing and tail control surfaces gaskets. Lift the gaskets gently and insert ONE layer of cloth underneath, then move along the whole span of the gasket. Ultimately, you may wish to apply Teflon grease (in spray) over the area where the gaskets touch the control surfaces. Polishing by hand Use only the highest quality polishing pastes WITHOUT abrasive grain, such as Sonax Extreme no.1 or similar. Start polishing on a clean, dry and cool surface, never in the sunshine! Machine polishing requires more skills and has its own particularities, therefore it is recommended to leave it to a professional. Cleaning the Plexy-glass transparent surfaces It is most important to use really clean water (no cleaning solutions are necessary) and a really clean drying towel (always use a separate towel ONLY for the glass surfaces). Should the glass surfaces be dusty, remove the dust first by puring water (not spraying!) and gliding your hand over the surface. Using the drying towel, simply glide it over the surface, then squeeze it and soak it before touching the glass again. If there are bugs on the windshield, soak them with plenty of water first, so less wiping is necessary. Ultimately, dry the whole surface and apply JT Plexus Spray ($10 USD / €10 EUR per spray) or at least Pronto antistatic (transparent) spray and wipe clean with a separate soft cotton cloth.
www.pipistrel.si TAURUS <strong>ELECTRO</strong> 85 Appendix REV. 0 Appendix Conversion tables Preflight check-up pictures
Page 1 and 2:
Flight manual and Maintenance manua
Page 3 and 4:
www.pipistrel.si TAURUS ELECTRO 3 R
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
www.pipistrel.si TAURUS ELECTRO 9 G
Page 11 and 12:
www.pipistrel.si 3-view drawing TAU
Page 13 and 14:
www.pipistrel.si TAURUS ELECTRO 13
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
www.pipistrel.si Landing gear failu
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34: www.pipistrel.si TAURUS ELECTRO 33
Page 41 and 42: www.pipistrel.si Roundout and touch
Page 49 and 50: www.pipistrel.si Maneuver & gust en
Page 51 and 52: www.pipistrel.si Additional technic
Page 57 and 58: www.pipistrel.si Definitions and ex
Page 59 and 60: www.pipistrel.si Flight mass and c.
Page 67 and 68: www.pipistrel.si Power plant, prope
Page 83: www.pipistrel.si Keeping your aircr
show all

Taurus ELECTRO manual 472 ENG.pdf - Pipistrel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?