MX-M283N/M363N/M453N/M503N Operation-Manual GB - Sharp

SYSTEM SETTINGS
Item Factory default setting Page
Disabling of Finisher* 5 Disabled 7-68
Disabling of Offset Disabled 7-68
Disabling of Stapler* 5 Disabled 7-68
Disabling of Punch* 6 Disabled 7-68
● Fusing Control Settings 60 - 89g/m 2 (16 - 23 lbs.) 7-68
*1 When a saddle stitch finisher is installed.
*2 When a finisher (large stacker) is installed.
*3 When a large capacity tray is installed.
*4 When a stand/1 x 500 sheet paper drawer / stand/2 x 500 sheet paper drawer is installed.
*5 When a saddle stitch finisher or finisher is installed.
*6 When a punch module is installed.
Copy Function Settings
Item Factory default setting Page
■ Copy Function Settings 7-69
● Initial Status Settings
Paper Tray
Varies depending on the machine
configuration
Exposure Type
Auto
Copy Ratio 100%
7-69
2-Sided Copy
1-Side to 1-Side
Output –
● Other Settings 7-70
Copy Exposure Adjustment 5 7-70
Rotation Copy Setting Enabled 7-70
Add or Change Extra Preset Ratios – 7-70
Setting a Maximum Number of Copies 999 7-70
Initial Margin Shift Setting
Side 1 10 mm (1/2")
7-70
Side 2 10 mm (1/2")
Erase Width Adjustment
Edge Clearance Width 10 mm (1/2")
7-70
Centre Clearance Width 10 mm (1/2")
Card Shot Settings
Original Size X: 86 mm (3-3/8"), Y: 54 mm (2-1/8")
7-70
Fit to Page
Disabled
Automatic Saddle Stitch* Enabled 7-70
Initial Tab Copy Setting 10 mm (1/2") 7-70
Disabling Deletion of Job Programs Disabled 7-71
7-33
Contents