Versa 5000 Series Service and Reference Manual - Support

Technical Information 1-5
„ The Battery/Charging Status LED is located on the right-hand LCD
hinge and lights to indicate the following:
⎯ Green – the battery is fully charged and the system is connected to
AC power.
⎯ Amber – the battery is recharging.
⎯ Off – the AC adapter is disconnected or the battery is not installed.
„ A bank of status LEDs is located on the chassis at the top of the keyboard
to the right of the Power button. These LEDs are identified by
icons and include the following (described from left to right):
⎯ The Power LED lights in the following sequence to indicate system
operation status.
– lights green when running on AC power.
– blinks green when the system is in Suspend mode.
– lights amber when running on battery power with
a charged battery.
The Power LED also warns you about a low battery state. The
system emits a beep and the Power LED behaves as follows:
– blinks amber when battery power is low.
– flashes amber when battery power is extremely
low.
The Power LED remains unlit under the following conditions:
– if the system is not connected to AC power and
the battery is not charged or installed.
– the system is not powered on.
– the system is in Save to Disk mode.
⎯ Hard Disk Drive – Lights when the NEC Versa 5000 writes data to
or retrieves data from the hard disk drive.
⎯ CD-ROM Reader – Lights when data is read from a compact disc in
the CD-ROM drive.
⎯ Diskette Drive – Lights when data is written to or retrieved from the
3.5-inch diskette drive.
⎯ Caps Lock – Lights when Caps Lock is on.
⎯ Num Lock – Lights when Num Lock mode is active.