D7W TS.pdf - Espar
D7W TS.pdf - Espar
D7W TS.pdf - Espar
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
14<br />
6 Exhaust Connection<br />
A 30mm flexible stainless steel exhaust pipe (1<br />
meter long), exhaust clamps and holders are<br />
provided with the heater kit. Connect the<br />
exhaust as follows:<br />
Caution:<br />
Run exhaust so that it cannot be<br />
plugged by dirt, water or snow.<br />
Ensure the outlet does not face into<br />
the vehicle slip stream.<br />
Install exhaust pipe with a slight<br />
slope or drill 5mm holes in lowest<br />
point to allow water to run off.<br />
Any restriction in exhaust will cause<br />
operational problems.<br />
Feed the exhaust pipe through the silicone<br />
(white) gasket on the bottom of the box. Run to<br />
an open area to the rear or side of the vehicle so<br />
that fumes can not build up and enter the cab or<br />
the heater box.<br />
Secure the exhaust pipe internally at the heater<br />
and externally using clamps and holders provided.<br />
Figure II J.<br />
Figure II J<br />
Warning: The exhaust is hot, keep a<br />
minimum of 2” clearance from any heat<br />
sensitive material<br />
Warning: Route exhaust so that the<br />
exhaust fumes cannot enter the passenger<br />
compartment.
Change language