5-Cylinder Operating Manual - Zanshin
5-Cylinder Operating Manual - Zanshin
5-Cylinder Operating Manual - Zanshin
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
INSPECTION<br />
Seawater filter*<br />
Cleaning seawater filter*<br />
BM5-006M<br />
Important<br />
● Never open the filter housing<br />
with the seawater valve open to<br />
prevent water from entering.<br />
● Observe the safety precautions<br />
beginning on page 22<br />
before performing any work on<br />
the engine or in the engine<br />
compartment.<br />
If you deterimine soiling, proceed as<br />
follows:<br />
● Close the seawater valve.<br />
● Unscrew the screws - see left illustration<br />
- and remove the cover.<br />
● Remove the filter element, flush it<br />
thoroughly with clean water and refit it.<br />
● Before screwing on the filter cover, the<br />
sealing ring should be lubricated, e.g. with<br />
silicone oil or Teflon spray.<br />
● Check the cover and the gasket for<br />
correct seating.<br />
Important<br />
If a cover is not seated correctly,<br />
air can also be aspirated, causing<br />
the engine to overheat.<br />
● Open the seawater valve again.<br />
● Start the engine and conduct a visual<br />
inspection of the seawater filter* for leaks.<br />
As the degree of soiling of the seawater<br />
filter is depending on the water the engine<br />
is operated in, you should check the filter for<br />
soiling each time before starting the engine.<br />
As the cover of the filter housing is transparent,<br />
you do not need to open the cover.<br />
INSPECTION 49<br />
49