Download - Tech-Rentals

Environmental, OHS, Chemical & Laboratory
www.techrentals.com.au
Water Quality, pH Meters
& Electrochem cont’d.
Hydrolab Minisonde 5 Multiprobe
Water Logger
HYD,MS5 (6020)
AU
Miniosonde 5 multiprobe water/borehole logger,
including ‘Surveyor’ data collection system with
GPS. Includes sensors for Dissolved Oxygen
(HACH LDO), Conductivity, pH, Redox (ORP),
Turbidity (Self-Cleaning), Temperature, Depth (0
to 25m) and GPS position. Includes the surveyor
data aquisition system so no laptop is needed for
download or data collection. Includes a 25m cable.
ISCO 6700 Series Water Sampler
ISCO,6712 (6057)
AU
Advanced water sampler for fully programmed
collection. Samples are collected in up to 24
disposable plastic containers based on time, flow,
and/or parameter set points. Fitted with NEMA 4X,6
(IP67) sealed controller featuring an exclusive,
built-in pump.
Isco 6700 Series Water Sampler with Bubbler
Flow Module
ISK,6700-730 (6056)
AU
Advanced water sampler for fully programmed
collection. Samples can be collected in 1, 2, 8, or 24,
1 litre disposable sample containers based on time,
flow, and/or parameter set points. Fitted with NEMA
4X,6 (IP67) sealed controller featuring an exclusive,
built-in pump, flash memory for easy programming
changes, and a plug-in module port for connection of a flow meter module or
parameter measurement module to enhance monitoring capabilities. Provided
with bubbler flow module. Sample bottles available. Run from rechargeable
12V sealed batteries.
OTT KL010-150 Ground-water Depth Measurement Contact Gauge 150m
OTT,KL010-150 (6065)
AU
Contact gauge for portable depth to water measurement. Used for wells,
observation pipes, bore holes and control pumping tests. 150m depth of tape.
as soon as the probe touches the water surface an acoustic signal beeps and
the lamp on the instrument lights up. The depth is read from the measuring
tape in meters.
Solinist Oil/Water Interface Meter
SOL,122 (6066)
AU
Used for bore determination of LNAPL or DNAPL levels. Flat tape on a reel
when lowered down a bore hole a light and tone indicate the LNAPL (Light
Non-Aqueous Phase Liquid) layer or the DNAPL (Dense Non-Aqueous Phase
Liquid) level. The level is measured from the 50m tape.
TPS 90FL-T Water Quality Meter
TPS,90FL-T (6028)
AU
Field meter and logger for water
quality measurements. Configured with
independent probes for pH, conductivity/
salinity[TDS]/temperature,
dissolved
oxygen[DO] and turbidity. Cables 5m with
probe holder and safety harness. LCD display
readout with simultaneous display of all measurements. Manual, “notepad”
storage or automated data logging for up to 1,808 sets of readings by time
and date. RS232C interface, with WinTPS software included. Supplied with
rechargeable battery, and clip-lead for operation from a 12V source such as
a car-battery.
Water Quality, pH Meters
& Electrochem cont’d.
TPS Conductivity Probe With Cell K=0.1
TPS,LOW K PROBE ( 6016)
AU
Plastic-bodied conductivity and temperature sensor for WP series meters.
With k=0.1 and automatic temperature compensation ATC. For precision
measurement at low conductivity levels. Minimum range with WP-84 2 uS/cm
to 2,000uS/cm. Temperature range -10 to 60°C. Fitted with 5m cable.
TPS Redox Electrode
TPS,REDOX (6004)
AU
Silver/chloride Redox electrode for use with TPS LC80A Ph meter. Supplied
with 2 bottles of Zobell solution for calibration. 1:1 dilution gives approx.
231mV.
TPS WP-80 pH and Temperature
Meter
TPS,WP-80 (6003)
AU
Portable hand-held meter for pH, mV and
temperature. Supplied with combination pH
electrode and separate temperature sensor on
1m cables. Operating ranges 0 to 14pH and
-10 to 120ºC (automatic sensor recognition
with auto pH correction 0 to 100ºC). Case water resistant to IP67, connectors
to IP65. Menu driven, with alphanumeric display. Auto storage of time and date
of last calibration for GLP. Memory for 2400 readings of data, time and date,
for Notepad results collection, or for AutoLog with logging intervals between
1s and 90h. Fitted with RS232C interface and supplied with downloadsoftware,
charger and solutions. Rechargeable NiMH battery gives up to
50h operation.
TPS WP-80 pH and Temperature Meter
for Testing Meat
TPS,WP-80M (6002)
AU
Portable hand-held meter for pH, mV and temperature.
The instrument is capable of applying Bendalls
equation to the pH reading for Meat Standards Australia
grading requirements. Supplied with combination pH
electrode and separate temperature sensor on 1m
cables. Operating ranges 0~14pH and -10~120ºC
[automatic sensor recognition with auto pH correction 0~100ºC]. Case water
resistant to IP67, connectors to IP65. Menu driven, with alphanumeric display.
Auto storage of time and date of last calibration for GLP. Memory for 2400
readings of data, time and date, for Notepad results collection, or for AutoLog
with logging intervals between 1s and 90h. Fitted with RS232C interface and
supplied with download-software, charger and solutions. Rechargeable NiMH
battery gives up to 50h operation.
TPS WP-82 Dissolved Oxygen
Meter
TPS,WP-82 (6009)
AU
Portable hand-held dissolved oxygen and
temperature meter. Operating ranges 0
to 20ppm, 0 to 240% saturation, 0 to 45%
gaseous and ppm with salinity correction.
temperature range -10 to 120°C. Case water
resistant to IP67, connectors to IP65, with
3m detachable cable and ED1 electrode.
Menu driven, with alphanumeric display.
Auto storage of time and date of last calibration for GLP. RS232C interface,
and memory for 150 readings of data, time and date, for Notepad results
collection, or for AutoLog results collection with logging intervals between
1min & 24h. Rechargeable NiMH battery gives up to 75h operation. Supplied
with download-software, charger and solutions.
72