4 IN 1 METAL DETECTOR - Harbor Freight Tools
4 IN 1 METAL DETECTOR - Harbor Freight Tools
4 IN 1 METAL DETECTOR - Harbor Freight Tools
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
9.<br />
10.<br />
11.<br />
12.<br />
13.<br />
To distinguish between a “hot” wire and a ground wire, set the Selection Switch<br />
(4) to the “II” position. (See Figures B and H.)<br />
Turn the Sensitivity Knob (3) forward to its end for maximum sensitivity.<br />
(See Figures B and H.)<br />
Move the AC Voltage Detection Area (6) of the unit near the wires to be detected.<br />
(See Figures B and H.)<br />
Reduce the sensitivity to a suitable level by turning the Sensitivity Knob (3) backward.<br />
(See Figures B and H.)<br />
Compared with the neutral line, the “hot” wire can cause the unit to give a signal<br />
at a farther distance. (See Figures B and H.)<br />
AC VOLTAGE DETECTION AREA<br />
(6)<br />
FIGURE H<br />
14.<br />
To locate a break in a wire, the procedure is similar to the previous steps. Set the<br />
Sensitivity Knob (3) to a suitable lower level. When the signals of the LED Light<br />
(2) and Buzzer are interrupted, the break in the wire is found.<br />
(See Figures B and I.)<br />
AC VOLTAGE DETECTION AREA<br />
(6)<br />
FIGURE I<br />
SKU 97244 For technical questions, please call 1-800-444-3353.<br />
Page 10